4 NHTSA recall campaigns have been issued for the 2005 Mazda Tribute. Click any campaign to view full defect, consequence, and remedy details.
Component: SUSPENSION:FRONT:WHEEL BEARING
The Timken Company (Timken) is recalling certain aftermarket front wheel bearings, part number 510072, sold from January 22, 2015, to May 21, 2015, to be used as service parts on 2001-2012 Ford Escape, 2001-2011 Mazda Tribute, and 2005-2011 Mercury Mariner vehicles. The affected wheel bearings have incorrect dimensions of a 42mm bore, 76mm outer dimension, and 39mm width, instead of a 42mm bore, 78mm outer dimension and a 45mm width.
Consequence: Use of an incorrectly sized wheel bearing can adversely affect the braking and steering of the vehicle, increasing the risk of a crash.
Full recall detail →
Component: ENGINE AND ENGINE COOLING
Mazda is recalling certain model year 2001 through 2006, and 2008, Tribute vehicles equipped with 3.0L V6 engines and speed control. Inadequate clearance between the engine cover and the speed control cable connector could result in a stuck throttle when the accelerator pedal is fully or almost-fully depressed. This risk exists regardless of whether or not speed control (cruise control) is used.
Consequence: A stuck throttle may result in very high vehicle speeds and make it difficult to stop or slow the vehicle, which could cause a crash, serious injury or death.
Full recall detail →
Component: SEATS:FRONT ASSEMBLY:HEAD RESTRAINT
CERTAIN SPORT UTILITY VEHICLES EQUIPPED WITHOUT SIDE AIR CURTAINS OR MOON ROOFS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 201, "OCCUPANT PROTECTION IN INTERIOR IMPACT." DURING TESTING, THE FREE MOTION HEAD FORM REGISTERED A MEASUREMENT ABOVE THE PERMITTED LIMIT AT THE LEFT HAND A-PILLAR TRIM AREA.
Consequence: IN THE EVENT OF A VEHICLE CRASH, PERSONAL INJURY TO OCCUPANTS MAY OCCUR.
Full recall detail →
Component: LATCHES/LOCKS/LINKAGES:HATCHBACK/LIFTGATE:LOCK
CERTAIN 2004-2005 SPORT UTILITY VEHICLES AND CERTAIN 2001-2003 SPORT UTILITY VEHICLE HAVING REAR LIFTGATE COMPONENTS SERVICED WITH 2004 EQUIVALENT COMPONENTS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 206, 'DOOR LOCKS AND DOOR RETENTION COMPONENTS.' THE REAR LIFTGATE LATCHING SYSTEM DOES NOT MEET THE INERTIA LOAD REQUIREMENT IN ONE DIRECTION.
Consequence: IF THE LIFTGATE IS LEFT UNLOCKED, THERE IS THE POTENTIAL THAT IT MAY OPEN DURING A CRASH.
Full recall detail →