Loading vehicle data from NHTSA...
NHTSA recalls, safety ratings, and consumer complaints for the 2012 Mazda Mazda3.
| Overall Rating | |
| Frontal Crash | |
| Side Crash | |
| Rollover |
| Overall Rating | |
| Frontal Crash |
Component: STRUCTURE:BODY:HATCHBACK/LIFTGATE
Mazda North American Operations (Mazda) is recalling certain model year 2010-2013 Mazda3 and Mazdaspeed3 vehicles manufactured November 18, 2008, to June 8, 2013, 2012-2015 Mazda5 vehicles manufactured October 26, 2010, to June 22, 2015, 2016 CX-3 vehicles manufactured June 1, 2015, to December 26, 2015, and 2013-2016 CX-5 vehicles manufactured December 15, 2011, to December 26, 2015. On the affected vehicles, the lift gate support struts may corrode, possibly causing the struts to break and/or the lift gate to drop unexpectedly.
Consequence: If the lift gate falls unexpectedly, it may hit the user, increasing their risk of injury.
Remedy: Mazda dealers will replace the both lift gate supports, free of charge, however parts are not currently available. The recall began April 2017. Owners may contact Mazda customer service at 1-800-222-5500. Mazda's number for this recall is 9916H.
The contact owns a 2012 Mazda Mazda3. The vehicle was transported from the east to Texas, and the vehicle was bought used. The contact stated that the dashboard was sticky and that a gap was between the instrument panel and cover. The contact stated that a small to medium bubble had started to form. The vehicle was not taken to the dealer or an independent mechanic. The vehicle was not repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 100,000. The VIN was not available.
The car leaks gas when the tank is full and if the car is inclined slightly. I've noticed the problem several month ago with an occasional odor but finally saw the gas leaking recently when it was parked on a sloped street.
The brake pedal is soft and sometimes unresponsive unless it is pumped repeatedly. There have been several times where I have been concerned if I would come to a complete stop. I have had both sets of brake pads replaced in the last year, and have on driven 9,000 miles. Two independent service centers diagnosed the problem as a faulty master cylinder. However, upon replacing the master cylinder and doing three brake flushes, and inspecting my brake pads and calipers, the problem persisted and is unresolved. They directed me to order a new ABS module, believing that that is the only other part that could be causing the cars brake problems. This part (BFY1437AZCO) is on backorder until November 2025.
The 2012 Mazda Mazda3 has 1 NHTSA recall and 226 consumer complaints on file. It received an overall safety rating of 4 out of 5 stars in NHTSA crash testing. The high number of complaints suggests potential reliability concerns — review the complaint details above before purchasing. For the most detailed information about a specific vehicle, decode its VIN using our free decoder above.
Enter a specific VIN to get the full report — specs, recalls, safety ratings, complaints, investigations, and technical service bulletins.
| Side Crash |
| Rollover |
The Seat Lifter on the driver's side seat frame broke, the metal has a clear stress fracture right near the bracket where the frame connects to the rail. This is the same part that was recalled in the 2010 and 2011 Models by Mazda in 2017. NHTSA Campaign No. 17V-082 It causes the driver side seat to change positions while driving creating hazardous conditions and does not appear structurally stable if involved in an accident potentially putting the driver's life at risk.
Our fuel tank is leaking for no reason. Brought it in last year (2024) for state inspections and let them know we smell gas when we park sometimes. They poke around and find nothing, but note there is a faint gas smell and to bring it to the dealer. We take it to Mazda to see if they can fix, they find nothing and charge my wife $250. Fast-forward to a year later, go for the same state inspection and we get failed. Our mechanic says theres a noticeable gas leak from the fuel tank and to take it to Mazda. There is clearly some issue with the fuel tank parts. The car itself only has 77k miles and it is 13 years old.
The contact owns a 2012 Mazda Mazda3. The contact stated that after refueling the vehicle, there was an abnormal gasoline odor inside and outside the vehicle for the next 5 days, prompting the contact to only fuel the vehicle halfway. The contact observed fuel leaking underneath the vehicle near the fuel tank. No warning lights were illuminated. The vehicle was taken to an independent mechanic, who diagnosed a failure with the welded fuel tank nipple fuel line connector. The contact stated that the component was cracked along the bottom of the weld. The contact was informed that the fuel tank needed to be replaced. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was 81,000.
2012 Mazda3i 5dr hatchback. Persistent issue with headlights, both low beam and high beam, as well as interior lighting and other lighting. The headlights flicker for several seconds any time the brake pedal is applied. Interior lighting also flickers when brake pedal is applied. Headlights sometimes flicker when vehicle is decelerating and no brake pedal is applied, most notable when vehicle is traveling downhill. Further, the luminosity (brightness) of the headlights visibly dims, but does not flash, when the vehicle is parked and the brake pedal is applied. A high volume of others report the same issue, including documented complaints. These vehicles are unsafe, defective as designed, and do not conform to FMVSS No. 108. NHTSA must investigate further. Many other owners are not aware of the cause of the issue and attempt to fix it by replacing headlights, alternator, etc. Mazda was aware of issue prior to July 2013, when it issued TSB 01-019/13. This document states, "Some vehicles may exhibit the headlights flickering when the vehicle is decelerating (by applying the brakes) with the headlights on. This concern is caused by inadequate alternator output (controlled by the PCM) when the battery is under a heavy load. To correct the problem, the control logic of the PCM has been changed." This appears to be at best a temporary fix. Bommarito Mazda in Missouri required payment of $199.88 to "diagnose" this problem and address it in the manner prescribed in TSB 01-019/13. This service was not covered under warranty. Service Manager M.D. claimed to have never heard of this issue before and that it would need to be diagnosed, despite being informed by the owner of the precise issue, that others reported experiencing the same issue, and that others reported the issue was addressed by reprogramming the PCM. Immediately following this service, the headlights continued to visibly dim when the vehicle is parked and the brake pedal applied.
The Mazda dealership reported to me the push rod was broken, that it ‘just snapped’. The car was towed by Zaben towing company courtesy of the auto insurance company associated with the vehicle to the Mazda dealership, however the towing company was on its way to another Mazda dealership per their app despite a clear address location given by the purchaser of the auto insurance. I found one of the hubcaps missing and placed in back seat of the Mazda after delivery and the Mazda not parked properly at Mazda dealership. The hubcap was not in back seat prior to the drop off. The clutch snap, as described by Mazda, did not happen while I was driving the vehicle. It was working perfectly fine two days prior to the discovery of collapsed clutch when I was driving around town. The clutch was found not working, collapsed after the car was parked for two days. Also, Texas Mazda dealership recommended another eight hundred dollar worth of work totaling near two thousand dollars yet I have between ninety and ninety six thousand miles on a twenty twelve Mazda three sport sedan. I mainly drive it in the city. The Mazda dealership recommended the valve cover and slave cylinder be replaced as well. They need to clean out air system, ‘bleed system’ too.
Weak braking and spongy brake pedal created near accidents at highway speeds. Brake pedal needs to be pumped to get firmness. But the check engine warning light did not come on, either. So I had mechanics replace front rotors, front disc pads, and bleed/refill system with fresh brake fluid and inspect system for leaks. But spongy brake pedal problem was not fixed. So when I researched the problem on the internet, it appears that it's a systemic, long-time (10 model years or more) safety issue with Mazda that they failed to recall nationwide. Totally irresponsible. Among Mazda owners, after replacing all other brake system components and not solving the spongy brake pedal issue, it turned out to be a faulty ABS System Module, a $2,000 to $3,000 repair at Mazda dealerships.
Car started jerking and on the way home, the car lost all power to the transmission. The check engine light came on as well as the AT and traction lights. Absolutely no power to the transmission. codes P0780 and P0751.
My issue is with computer firmware updates the manufacturer (Mazda) needs to have done occasionally to help w/traction control and other issues, that the consumer is stuck paying for it, I had a check engine light come on and took it to the dealer. The dealer said that the TCM (traction control module)and the PCM (power control module)needed to be updated. And being the car was out of warranty that I was going to be responsible for paying $330. I would think that if a manufacturer decided to make new updates to help with safety and performance that it shouldn’t fall on the consumer as we bought the car thinking they had this stuff already figured out. Like our smart phones when there updates we the consumer don’t pay for the updates to help protect our phones from security issues and other things…. So why is it acceptable for consumers to pay for auto industry’s updates to help with safety.
The dashboard of my 2012 Mazda 3 has separated from the instrument panel causing a gap between them. The dashboard has become very sticky leaving a black sticky film on the surface. This has caused a glare on the windshield making it hard to see at times while driving. There is a letter dated May 2017 from Mazda, Special Service Program (SSP) A9. The letter states that the warranty was extended 7 years (84 months) from the original warranty start date or April 30, 2018, whichever is later, with no milage limitation. As I read it, 7 years of 84 months from 2018 should extend the warranty for repair of replacement through 2025. Mazda refuses to make repairs, or replacement of this equipment that has an impact on the proper function of the airbag system and impairs the driver's vision because of the constant windshield glare. This is an issue. that needs to be addressed as an important safety.
[XXX] covers a safety oriented problem with my car. Jim Ellis Mazda in Marietta refuses to work on my car because it is more than 10 years old. This is a proprietary issue since it deals with the computer system in the car. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
Headlight flickering and turns off and on randomly.
Showing 15 of 226 complaints